I am running the stock twins in sequential mode. After adding a greddy smic, my knock has been bad. I see on my commander than my boost is spiking just shy of 12 psi. Where can I set on the commander to limit it to 10 psi, or to verify that it is set at 12 psi and something else isn't going wrong?

after searching I have seen several statements saying I don't need the boost control kit for stock setup, but nothing to just how to set it.

 

Its more than likely your wastegate and not your powerfc.

 

Here's the setting from commander:


If I change all #'s to .7, would that prevent boost from going so high?

 

In short yes, but take the time to read this thread.


https://www.rx7club.com/3rd-generation-specific-1993-2002-16/how-make-your-untuned-pfc-basemap-safer-idle-better-no-datalogit-needed-841706/

 

I wrote that whole thread and I will say that the answer is maybe. I gave him some settings to try via PM. When he gets the Datalogit we will have a better idea because he can log precontrol and wastegate control solenoid duty cycle after that.