Ok, well I noticed that my 1300 secondaries are leaning so I have decided to replace them with Bosch 1680cc injectors however I am required to run a resistor for each 1680cc I use. Now my questions how would I run the resistors and what level of resistance should I get? My plan was to run 1 resistor as close as I safely can or does it not matter? Also seeing that a resistor will "lag" the injectors, what settings must I change my values to? for my 1300cc's I just changed the 850 value to 1300 and did not trouble the "lag time" feature. Now that I am creating a lag through the resistors just how much do I change the value? I plan to compare other maps I have access to but I prefer to ask the forums before I use another persons values without the full understanding.

 

Injectors are either High resistance or LOW resistance.,
It has nothing to do with lag time.

Here..read this:Fuel Injector Lag Time

and some stuff I found:http://fuelinjectorclinic.com/faqs

 

Thanks!!! this is exactly what I needed!!!!