Last Saturday night I went Non-seq and also installed the PowerFC. It ran ok at first, just revving up to hunt idle and things like that.

Now, it's rumbling and going nuts. Shakes and tries to go to like 3 vacuum then goes back to about 11, then rumbles then back to about 3-4 then repeats with the AC on. With AC off, it just rumbles rough at about 11 vacuum. It shakes terribly and is just running like crap, basically.

Checked and no hoses appear to be off, map sensor is connected.

Now I know there's a learning mode, but how long does that take and is this part of the learning step? I've been driving it around since Monday and it is not improving.

Suggestions? Anyone in FL an expert PowerFC tuner?

(Anyone going to Rotorfest on Saturday an expert PowerFC tuner?)

Thanks

 

You should probably stick to one mod at a time lol. What are your mods? what map is in it right now? You should Post your map in zip format and your mods.

 

Damn, I put the mods in my sig but it's not showing up for some reason.

"93 Silverstone on Red-

-Streetport 2mm Hurley- ASI racing AST- Fluidyne Radiator- ASI racing FMIC- Full exhaust with Edelbrock MP- Greddy Profec B- PowerFC- Non-Seq- Unorthodox Pullies- Petit Boost Gauge- Autometer Water and Oil Temp- Greddy Elbow- Greddy BOV- Brembo Drilled/Slotted Rotors- Hawk HP pads- 4 x 850cc injectors- SupraTT Pump- 9.5lb Flywheel- ACT S/S Clutch- B+M Short Shifter- "

What map is in it right now? Whatever comes on it from Rx7store. :-\

<--- aftermarket ECU map newb, be kind.