I bought a used PFC for my 94 rx7 and I have intake, DP, CB, and High flow cat on midpipe. I have heard that new...the PFC ships with some modified maps for intake, etc. The guy that I bought it from was running a single turbo. I have the stock twins. I installed the PFC and it would run on opt. 1 and opt. 3-5...but not opt 2...so I am assuming that he had option 2 re-mapped for his single turbo. Now assuming that he left opt. 1 as the base map (not that it matters cause I loaded a base map onto it). And assuming he didnt mess with options 3-5, which option/map should I run for my mods? Does anyone have a map that I could use...anyone with my same mods?

more specific on mods:

-custom intake (hardpipe and autozone cone filters.
-Mild steel down pipe (on the car when purchased).
-Blitz nurspec CatBack.
-High flow cat on midpipe.

Thanks,
Sean

 

There are no "options" for different maps with the PFC. It only has one map. It sounds like you are talking about the PIM settings, in which case you should be using the "normal" setting.

If I were you, I would:

*reset the PFC to default settings
*add a little bit (2-3%) of fuel under boost to be safe
*get the PFC tuned