Hey guys just installed my power FC in my rx7

I followed the Diy on it cut the 4 wires and erased any old maps that was on there and adjust the idle screw.


I start the car and it rev and stayed at 3300 rpm for over 2 min is this normal?



Any help or suggestions would help me dearly



I forgot to mention
My idle bleed screws was closed when I turned it the 1/2 way.

 

No one has ever had this issue??? Plz help guys

 

Did you do the idle learn procedure like the manual says?
Have you checked that your settings arent set to idle at 3300rpm?

 

Ya I adjusted my idle valve screw and and adjusted the PFC idle to 870. So far so good