Hey guys,

I've been looking on here and in all the various bits of documentation I have and I can't find the answer, so hopefully someone will know....

Is there a way to change the PFC's water temp vs. resistance table? I'm asking because it would be easier for me to use a non-Mazda water temp sensor, specifically a GM one. See this thread here for my reasoning: https://www.rx7club.com/3rd-generation-specific-1993-2002-16/stock-thermosensor-curve-aftermarket-sensor-place-stock-751522/

Anyone know? I used to have a Supra with an AEM and it was possible on there, but I haven't messed with the PFC nearly as much yet.

- Andy

 

If you do not see it on a table, then you can't do it.
Otherwise, we might be able to also use a faster air temp sensor.