Hey guys,Quick question.My dads running a 3bar map sensor, And the 1bar map sensor is plugged in to the apexi on a short loom, Original equipment by the looks of it, next to the comander plug. There is no vac pipe on it .I have nexer seen this b4.Can someone enlighten me please.

 

pics please

 

Here you go.

 

which map sensor option is selected right now? Option 2? do you have a datalogit?

 

. Hi, Ecu is out at the moment, So i dont know. Just waiting on him to fit his rebuild in. I just thought it was strange to have to map sensors , But i think i can see where your going with this. Please can you elaberate so if he gets problems this will help.Thanks,Rix, ps no datalogic fitted yet.

 

when you buy the Apex'i boost control kit it comes with a harness like that and you plug the Apex'i 3 bar MAP sensor (which I believe is also made by Denso just like the factory sensor) into the side like you've shown. Then you can select option 2 under PIM volt, which uses a voltage scale for the Apex'i 3 bar.

 

Manythanks Arghx for your info.Engine should be in , in a couple of weeks as soon as he gets time.So any more info needed i will give you a shout,Manythanks, Rix