I will try to keep this quick for anyone interested in helping.

New twins and I am running off wg with no pre controller hooked up. So no pre controller or wg was hooked up. The hose from both pre control and wg controller were just looped back to one another. ( I assume this acts as a cap on both)

Goal. Install apexi boost solenoid and run factory pre controller before making the drive to get tune. Prior to that I would like to run the factory pre controller and keep the wg solenoid disconnected and run off wg spring. Boost control will be from pfc.

I just reinstalled the wg/PC solenoid. I have the nipple from wg actuator hooked up to the wg solenoid. The pre control actuator hooked up to the pre control solenoid. The other nipples on both actuators are boost source. I plugged in the pre control solenoid to factory plug.
I want to continue running off wg spring until I go for tuning. I will not hook up apexi wg solenoid until then.
Is there any danger in this?

When I hook up the apexi solenoid it will be as previous other post. I will just splice it in between the boost source and wg actuator. (Using pfc to control boost)
I believe leaving the other nipple on wg actuator hooked up to the factory wg controller that is not plugged in will act as a cap on that actuator nipple.

Is there any transition I should verify on the pfc for safety? Can I even Meeks anything up like this? Or if something is wrong it just won't function properly ?

 

Sorry guys I meant this to be placed in the 3rd gen forum.
There are a couple questions appropriate for the pfc masters in here though!