the setup:
stock port block
ap eng pfc + commander
gm 3 bar map sensor
fd ait
550 primary inj, 1680 secondary inj
stock ports
BW s300 tub
3" exhaust, de-cat
v-mount
profec b boost controller
(+other supporting mods)

the pfc was mapped for a large street port block and different tub (my old setup), since then i now have the above setup and the car is running rich.
i stupidly reset the pfc only to find out after that the commander can only change the secondary injectors to 1500cc max.

i have a datalogit (on its way to me) which i can then change the secondaries to 1680.
what other setting do i need to change before running the engine?

do i need to change settings to account for:
fd ait
gm 3 bar map?

anything else i not thought of?

any help much appreciated! thanks

(once its running and past annual test then will visit pro tuner for mapping)

 

What engine in what car?

 

fc s5 engine 13bt.
from what i have gathered its setup to run fd ait and 3bar map. so just need to change the secondary injectors.
hence the banzai harness kit.