Power FC My car wont "learn" idle??? 3k idle?
My car wont "learn" idle??? 3k idle?
Hey guy my car is having some issues with its idle, i have a single turbo, and all of the blockoff plates.... everytime i try to start up the car, my idle will go all the way up to 3000 rpm and not will not try to come down at all... i did cut the four wires, and i did try to reset the thing so i can "relearn" the idle again... any suggestions?
what four wires are you refering to?
actually my friend is having this same exact problem....it won't seem to learn...and it idles really funky. When u first step on the gas...it bogs a little then goes. Idle jumps a little. <shrugs> *scratches heads*
actually my friend is having this same exact problem....it won't seem to learn...and it idles really funky. When u first step on the gas...it bogs a little then goes. Idle jumps a little. <shrugs> *scratches heads*
Last edited by WONG FRIED RICE; Sep 2, 2005 at 09:53 PM.
Originally Posted by jupiter
Check you Idle Air Control valve. Section F pg 83 in the manual.
You can disconnect the connector at the valve and re-adjust your idle.
Until I can replace it. Mine was having the same problem.
You can disconnect the connector at the valve and re-adjust your idle.
Until I can replace it. Mine was having the same problem.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
ncds_fc
New Member RX-7 Technical
1
Aug 15, 2015 10:06 AM




