Power FC "INJ vs ACCEL TPS1" info
#1
Eye In The Sky
Thread Starter
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,895
Likes: 0
Received 114 Likes
on
66 Posts
"INJ vs ACCEL TPS1" info
As there isn't any helpful info about this table on this site or other RX7 sites, I decided to try experimenting with it and logging. But then my my exhaust leak has taken my car down for a while while it is being fixed.
While waiting I started searching the web for any info on it. All that I could find is in the attachment.
Maybe some of you with tip in leanest problems can research this while I await the return of my exhaust manifold.
Note: even other car groups complain about tuners withholding info like this because they make their living from it!
While waiting I started searching the web for any info on it. All that I could find is in the attachment.
Maybe some of you with tip in leanest problems can research this while I await the return of my exhaust manifold.
Note: even other car groups complain about tuners withholding info like this because they make their living from it!
#2
Senior Member
Join Date: Feb 2006
Location: mooresville
Posts: 454
Likes: 0
Received 0 Likes
on
0 Posts
wow an explaination.....where did you find it??
I started playing with it a few months ago because i was having a very light throttle light load hesittation and i had tried everything on the inrichment function with no results.
I ended up increasing lowest input from 25 to 200 (!!) and now i have zero off idle hesitation however i now have a small amount of bucking when it comes off of F/C so I will go back on it a little...just haven't had the time to get back to it in a while. but yes from my experience it seems to act the same why that doc. says it would.
the datalogit is awsome it sucks how incomplete most of the info is on it.
thanks cewrx7r1
I started playing with it a few months ago because i was having a very light throttle light load hesittation and i had tried everything on the inrichment function with no results.
I ended up increasing lowest input from 25 to 200 (!!) and now i have zero off idle hesitation however i now have a small amount of bucking when it comes off of F/C so I will go back on it a little...just haven't had the time to get back to it in a while. but yes from my experience it seems to act the same why that doc. says it would.
the datalogit is awsome it sucks how incomplete most of the info is on it.
thanks cewrx7r1
Thread
Thread Starter
Forum
Replies
Last Post