i had old eCu in my car which i loved for backfires recently i bought power fc and installed.currently i am running 9 PSI. How will i make my car backfire through power fc or commander settings. Need a proper method. your advice would be highly appreciated.

 

Set your rev limiter to ignition cut.

 

Small exhaust leak between midpipe and cat back will do it.

 

In commander ill go to settings. Then where ill do that? I am a new user to it so i need your guidance like this for example

Settings> rev> limits

Please

 

Change the three F/C "fuel cut" values to 9000 along with the rev limit.

You could also increase the fuel values in the map for 0 psi and vacuum for the rpms above 3k in the area where the engine never runs.

 

This thing?

 

Are you trying to backfire on deceleration, or bouncing off the rev limiter?

 

So i just downloaded FC Edit. Looks like there is not an option for ignition cut, and power FC only supports fuel cut.

 

much props to you Mohammad can you upload a pic of your car! !!!!!?

 

If I wanted to backfire only when reving at standstill which one would I change? Under electrical load or under no load?