I just dropped in my new motor and it is not running right... I think it could be the PFC... Does anyone have a similar setup
MY MODS:
NS turbos
fmic
3" haste rad
walbro pump
3 bar map sensor


Any help is appreciated...
My motor does idle but it idles very rough. It idles from 400-800... When I give it gas, there is a hesitation and It does not rev well... It also is making a clunking noise... Sounds like it's coming from where the trans is mounted to the engine...

 

Fix the clunking, then worry about the PFC

 

The three bar map sensor is most likely your problem as you propably have not choosen the appropriate set up for it.

Commander: Settngs - PIM Volt
DL: Settings 3 - PIM Scale Offset

 

I have 1 map that should work fine with your setup. I also have a datalogit and laptop. I actually need to stop by anyway and finally pick up my wheels from you..lol.