Could someone please tell me what wires need to go where from the innovate wideband to the datalogit. Help Pleaseundefined

 

Try the bottom of this thread. You will have to refer to your manual for the LM-1 and program whichevey output you use. Then you will have to make a change under AUX in the FC-Edit software for the Datalogit too.

https://www.rx7club.com/power-fc-forum-47/connecting-lm-1-datalogit-other-sensors-471501/

 

What I have done is hooked up the yellow wire (output1) to the datalogit AUX 1 and the ground to the datalogits 0V. Is this correct???

 

Most people keep Analog for narrow band use.

Do this:
"In this case connect the Analog out 2 (white) to AN1, metallic (analog GND) to AN2. Program Analog out 2 to what translation of voltage to AFR you want."

Tony

 

You may find this interesting.

http://www.innovatemotorsports.com/r...1_Tutorial.pdf