Finally installed PFC on S5 T2 and trying to tune now, but I can't get fc-edit to read analog output from AEM gauge.

I added wideband on AUX on FC-EDIT adn checked delta AN1-2
connnect analog wire to AN1 and ground to AN2
I can see voltage on multimeter but keep showing 0 on fc-edit.
Added watch for it but still just 0.

is my datalogit broken??

 

Try this

https://www.rx7club.com/power-fc-for...alogit-912142/

 

thanks, I followed this and other thread using newer style AEM gauge.

problem is datalogit doesn't read even actual wire has boltage when I checked with multimeter.
I'm using regular ground for cables in dash panel.

 

did you try switching to a different AN position? you also must start logging before live data will show up.

 

I just did this, but everything is still 0
but yes finally only one time showed somehow when I uncheck and check again AUX A/D before run motor.... and won't read again now lol

start logging before run motor right??

Thank you for info!! so happy at least showed one time!

 

start the engine then hit start log, cycling the ignition can cause the datalogit to drop out.

 

WOW! thanks. finally number showed everytime on log!
done with scaling and ready to tune!

 

no problem, glad you got it going.