Datalogit doesn't show analog 0-5v from wideband gauge
Finally installed PFC on S5 T2 and trying to tune now, but I can't get fc-edit to read analog output from AEM gauge.
I added wideband on AUX on FC-EDIT adn checked delta AN1-2 connnect analog wire to AN1 and ground to AN2 I can see voltage on multimeter but keep showing 0 on fc-edit. Added watch for it but still just 0. is my datalogit broken?? |
|
thanks, I followed this and other thread using newer style AEM gauge.
problem is datalogit doesn't read even actual wire has boltage when I checked with multimeter. I'm using regular ground for cables in dash panel. |
did you try switching to a different AN position? you also must start logging before live data will show up.
|
Originally Posted by RotaryEvolution
(Post 12161060)
did you try switching to a different AN position? you also must start logging before live data will show up.
but yes finally only one time showed somehow when I uncheck and check again AUX A/D before run motor.... and won't read again now lol start logging before run motor right?? Thank you for info!! so happy at least showed one time! |
start the engine then hit start log, cycling the ignition can cause the datalogit to drop out.
|
Originally Posted by RotaryEvolution
(Post 12161125)
start the engine then hit start log, cycling the ignition can cause the datalogit to drop out.
done with scaling and ready to tune! |
no problem, glad you got it going.
|
All times are GMT -5. The time now is 04:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands