Power FC Correct Voltages for Check sensor function
Thread Starter
Senior Member
Joined: Feb 2003
Posts: 577
Likes: 0
From: Denver, CO
Correct Voltages for Check sensor function
I installed my PFC and the exhaust temp sensor it lit with the ignition on the on position. According to the PFC manual this means one of my switches or sensors is bad.
Here are my mods:
PFC
DP
MP
CB
Removed Airpump and A/C (A/C stuff for sale in the sale section)
Relocated stock temp sensor for the gauges to the thermo housing and have Greddy temp sensor in stock location.
The electrical attachment for the gauge temp sensor broke off when I was removing the airbox. I wouldn't think this would throw a code.
Anyway, does anyone have the correct range for the voltages shown in the check sensor/switch mode of the PFC with the car off and switch in the on position?
Thanks for the help.
Here are my mods:
PFC
DP
MP
CB
Removed Airpump and A/C (A/C stuff for sale in the sale section)
Relocated stock temp sensor for the gauges to the thermo housing and have Greddy temp sensor in stock location.
The electrical attachment for the gauge temp sensor broke off when I was removing the airbox. I wouldn't think this would throw a code.
Anyway, does anyone have the correct range for the voltages shown in the check sensor/switch mode of the PFC with the car off and switch in the on position?
Thanks for the help.
Registered Abuser
Joined: Sep 2001
Posts: 633
Likes: 0
From: Louisville, KY
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
Aug 22, 2015 05:52 PM
freq
2nd Generation Specific (1986-1992)
0
Aug 21, 2015 03:30 PM