Power FC Boost gauge reading 10psi, PFC seeing 1.3??
Thread Starter
Z06 powered FD
Joined: Mar 2001
Posts: 1,883
Likes: 0
From: Dallas, Texas
Boost gauge reading 10psi, PFC seeing 1.3??
I'm using a Profec B to control boost and my Blitz boost gauge sees 10psi, which is what I want. However the PFC reads that I'm hitting 1.30 so I had to set the PFC to 1.4 so that I didn't hit fuel cut.
Anyone know why it's reading so high?
Anyone know why it's reading so high?
Lives on the Forum
Joined: Dec 2001
Posts: 14,716
Likes: 10
From: San Lorenzo, California
Have you verified that your MAP sensor is putting out the correct voltages? Compare the readings you get from the sensor screen to the Service Manual.
Also, are you using the correct PIM(?) scale? It sounds like that could also be the problem. I can't remember how to adjust that off the top of my head, but it's in the manual.
Also, are you using the correct PIM(?) scale? It sounds like that could also be the problem. I can't remember how to adjust that off the top of my head, but it's in the manual.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
Mar 17, 2022 02:46 PM
