hey all...

am going to pick up a 3bar map sensor from the gm dealer....was wondering what else i need to do the install. Do I need to pick up a wiring harness and modify it?

what parts are needed for the conversion....Im assuming it is not plug and play..haha

I have the profec b and the power fc to handle control.

anyhow...let me know please


thanks guys...input would be greatly appreciated..


ALSO....what changes need to be made on PIM setting 1 in order to run it with my setup?


j

 

My main question is; does the GM 3 bar sensor "boost to voltage mapping" match the Apexi 3 bar? If not then the PFC mapping will have to be changed to "READ" true to the GM unit. Otherwize, the PFC will read boost incorrectly!

 

We'll know in another week. Bump this thread if no one answere by then.

 

^^^