how? install dakota spedo and tacho for fd 2jz
i'll save you a few bucks and some headache, well Dale did.
https://www.rx7club.com/3rd-generati...meter-1011051/
if the tranny already has an analog speedo driver it should work without the need of a calibration box. if it's a 2 wire output simply wire it up how the stock speedo is wired.
https://www.rx7club.com/3rd-generati...meter-1011051/
if the tranny already has an analog speedo driver it should work without the need of a calibration box. if it's a 2 wire output simply wire it up how the stock speedo is wired.
Last edited by RotaryEvolution; Sep 18, 2012 at 10:49 AM.
Thread Starter
Full Member
Joined: Dec 2006
Posts: 200
Likes: 0
From: Kuwait
i'll save you a few bucks and some headache, well Dale did.
https://www.rx7club.com/3rd-generati...meter-1011051/
if the tranny already has an analog speedo driver it should work without the need of a calibration box. if it's a 2 wire output simply wire it up how the stock speedo is wired.
https://www.rx7club.com/3rd-generati...meter-1011051/
if the tranny already has an analog speedo driver it should work without the need of a calibration box. if it's a 2 wire output simply wire it up how the stock speedo is wired.
but the big problem that my tacho and speedo didn't run or move ?
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
Nov 10, 2018 12:03 PM
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
