I did not take that many photos of this truck over the 4 years I owned it..


so as many events it was @ I know there are photos around the main Questions its where are thay at...

some of you might have seen it @ the last 3 Seven Stock events...

If you have them can you please post them..

Thank-you
Dan

 

I already posted these in the NW section, but I figured you guys would like to see them.

These were at the big BBQ late aug in either '05 or '06.

 

Thanks Jeff

I know there is someone else that has some more from a few Seven Stock events too...

Dan

 

Sorry mate, these are the only pics I have of your ride at Sevenstock #9. (at least i'm hoping this red one is yours!)

I was drooling over the dolphin thing you were parked next to, and completely missed taking any decent pics of your truck!

Cam...

 

Hey no problem and Thank-you..
SS9 was the last for this truck as it got hit by a 99 F250 on 01\04\2007 @ this time I am looking into building another and if I do it will be better than the red one..

Dan

 

Ouch! that sucks!

We had a B2200 turn up at one of our cruises with my local club ( haven't seen it for a while) sporting a 13BT conversion and rolling on 19's I think...was insainly quick for a truck, the guy was havin a ball with our current wet winter roads!!!!!!!!!!

Good luck with the new project, and watch out for the F-650's!

Cam...

 

Yeah good luck on your next rotary powered B-series.

Are you going to use thickwall pipe in the exhaust this time? Speaking of which, I'm fabricating an exhaust for my red '74 REPU right now. I'm half way done and fired it up on the fresh rebuild last night. Not too loud and has a nice mellow tone (Rotary Engineering glasspacks). It'll get a supercharger after it's broken in.

 

I used thick wall on the 2nd system on the last truck.. as for the next truck we will see what comes next..

Dan

 

Thanks , zAx

 

Sweet!

 

I drive an F250. I need to be careful of those homemade REPUs!

 

Calling a rotary powered B2200 a homemade REPU is like calling a rotary powered GLC a homemade RX-3. It just isn't done.

 

what did it look like, i took a ton of photos at SS9......

 

Boog there are some photos of it @ the top of this thread so that should give you some idea of what to look for...

Dan

 

Dan I'm pretty sure I took a few engine bay shots of it but the real question is where are they? I'm not sure if I took them in digital and have them on my hard drive or if I have older non digital photos. I'll dig around and see if I can find them but I can't promise anything.

 

I am not that worried as it was a newer Fake REPU and not a true REPU this was the main reasion I picked the chassey as thay are everywhere here in the NW where the old REPU's are a little tough to locate...

Plus if it did get wrecked I could get parts from anywhere from around the world. where a REPU I am limmited with parts and it would come down to would the seller\Collector be willing to sell parts...


Dan