13b te72 corolla
#1
Full Member
Thread Starter
13b te72 corolla
i havent posted in awhile here and since i have i sold my FB and got back my old corolla and finally got around to doing the swap i have always wanted.
Motor is mounted in the car, trans is mounted, driveshaft was made and is in the car, and now i just need small bits so i come asking for questions.
1. does anyone know how close a aluminum FB rad is to fitting in a te72?
2. should i plan on upgrading my rear end?
3. speedometer options?
Motor is mounted in the car, trans is mounted, driveshaft was made and is in the car, and now i just need small bits so i come asking for questions.
1. does anyone know how close a aluminum FB rad is to fitting in a te72?
2. should i plan on upgrading my rear end?
3. speedometer options?
#2
Full Member
Thread Starter
so after measuring a FB rad will not work and i do not want to cut my core support. Does anyone know a radiator i can run with the inlet and outlet on the correct sides?
#3
Can Post Only in New Member Section
Join Date: Aug 2015
Location: Arizona
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
#5
Can Post Only in New Member Section
Join Date: Aug 2015
Location: Arizona
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
My 1800 has a super narrow engine bay so im running a honda one, im not sure how well it holds up yet though. Ae86 ones have their outlets on the same side for a rotary. Most people i know use rx2 ones in a e7 though.
good luck!
good luck!
Thread
Thread Starter
Forum
Replies
Last Post
FC_fan
Old School and Other Rotary
5
10-02-12 08:08 PM