This might be a long shot. IDK how many people check the forum here anymore. But I was wondering if there's anyone in the Seattle area that has the rotor/main bearing tools? I have a press but I don't have the tool to locate the bearings. I know Atkins can do it but I figured I'd ask here before making the drive down there.

 

I’m in Kent
I have all the bearing press tools and a large press to effortlessly do the job.

 

Thanks a lot! I was able to find someone on FB in North Bend that let me borrow the tools. Good to know there's another rotor head in Kent though! I'm in the Renton highlands area.

 

Glad you were able to get the tools u needed . I’m in Kent east hill area so not far from the highlands.
what are you building?

 

S5 Turbo engine going into an '87 Turbo. The project is slow going at the moment as I don't have a lot of free time, but I'm planning to go EFR8374, Haltech Nexus R3, etc. Is your sig still accurate? I don't remember the last time I saw an FC around here. I see a few FDs from time to time.