New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

Wont Start help!

Old Sep 22, 2010 | 10:33 PM
  #1  
GreenMachine's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Apr 2009
Posts: 161
Likes: 0
From: Olds
Wont Start help!

my 89 turbo died as i was picking up to highway speed .At first i was speeding up then i just stopped gaining speed it stayed running for abit staying at the same speed even though i should have easily been going faster. Then after a few seconds it stalled. the radio and everything still works and it turns over quite fast but while trying to start it backfires sometimes. There is also spark so it is a fuel problem What should i check?

Also while i was looking around in the engine bay i saw that the air hose from the air meter to the turbo was cut or broken and on the air flow meter there was nothing connected to the side and there is some sort of electrical plugin there butim sure its been like that for along time.

Thank you
Shea
Reply
Old Sep 23, 2010 | 09:50 AM
  #2  
Aaron Cake's Avatar
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
If you have a break in the turbo inlet duct (the hose between the air meter and turbo) then you may have run the engine lean. Perform a compression test to make sure that it isn't blown before proceeding with any further troubleshooting.
Reply
Old Oct 6, 2010 | 01:51 PM
  #3  
GreenMachine's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Apr 2009
Posts: 161
Likes: 0
From: Olds
what if compression is good? How do i check for fuel
Reply
Old Oct 6, 2010 | 01:55 PM
  #4  
satch's Avatar
Moderator
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Jun 2005
Posts: 11,738
Likes: 16
From: tulsa,ok.
You could jumper the fuel check connector and w/key to on the pump should turn on. You could place a fuel pressure gauge in line after the fuel filter to check for pressure according to spec.
Reply
Old Oct 6, 2010 | 03:03 PM
  #5  
Aaron Cake's Avatar
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
See my answer in your other thread.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
ZacMan
Build Threads
4
Sep 19, 2015 09:20 PM
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
whinin
New Member RX-7 Technical
10
Sep 5, 2015 11:52 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:37 AM.