Ok well i have a na 90 vert, im ordering a s5 jdm turbo swap motor trans ecu and harness, is there anything i should know bout doing this swap, thanks..

 

take your time to do some Research on JDM shops and what they sell If you plan to purchase an engine.
They will tell you what you want to hear to get a sale,but if the engine is bad,it is your loss.
The Best bet is to go directly to the Place and inspect the engine thoroughly.Most of these engines have been powerwashed to look good,and water gets inside them,They sit for God knows how long and then when you get it?..it's Toast!
I'm not trying to sway you from your swap,I just want you to Know what you are getting into ahead of time.
If you can find a Decent Rebuilt,then you would be better of instead of a JDM "plop in and go" Crap shoot.
Then again,you can always get that big lawn ornament and rebuild it.A lot of guys opt to go that route.

 

Lmao no i gotta buddy with a running one full swap he just put a 26b in. I def know how jdm swaps go lol thanks h motors, will i need to do anything to harness or aything else like sensors??

 

See 2nd gen FAQ and the link in my sig.

https://www.rx7club.com/2nd-generati...7/#post5131155

 

Thanks everything i needed

 

What is a good big Turbo for a 13b 2nd Gen NA high comp

 

what did you decide? can't wait to see how it goes, i plan to buy similar and do a turbo motor swap