TII Swapped Vert, Not running correctly
#1
TII Swapped Vert, Not running correctly
I have an '88 Vert with an '87 TII engine just recently swapped everything over.
I am running a stock S5 turbo with Rtek 1.8 720cc injectors all around.
Custom FMIC setup with blow-through AFM and simplified throttle body.
Engine has a total emissions delete and all the block-off plates.
Simplified vacuum system to go with the above.
I am using the Stock N/A wiring harness to run the engine.
Okay so the issue is that the car will not idle, has a hard start, and will not rev properly. To me it sounds like one rotor. I had all the injectors cleaned and flow tested, wired in new injector clips. I have tried replacing the CAS (three times!), even re-timed the engine and still no results. The engine still sounds like it has great compression on all rotors. The donor car had none of these issues so I am pretty stumped.
So think anyone can chime in here? Any ideas are welcome
I have a video and will be uploading soon!
I am running a stock S5 turbo with Rtek 1.8 720cc injectors all around.
Custom FMIC setup with blow-through AFM and simplified throttle body.
Engine has a total emissions delete and all the block-off plates.
Simplified vacuum system to go with the above.
I am using the Stock N/A wiring harness to run the engine.
Okay so the issue is that the car will not idle, has a hard start, and will not rev properly. To me it sounds like one rotor. I had all the injectors cleaned and flow tested, wired in new injector clips. I have tried replacing the CAS (three times!), even re-timed the engine and still no results. The engine still sounds like it has great compression on all rotors. The donor car had none of these issues so I am pretty stumped.
So think anyone can chime in here? Any ideas are welcome
I have a video and will be uploading soon!
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
get the wire colors to the injectors and see of they match to the Locations.
I did a N/A to TII swap where the Injectors were switched and it was Hell!
SATCH may jump in to tell you colors on the wires,if he sees this.
I did a N/A to TII swap where the Injectors were switched and it was Hell!
SATCH may jump in to tell you colors on the wires,if he sees this.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
josef 91 vert
2nd Generation Specific (1986-1992)
23
09-03-15 11:20 AM