ok, Im somewhat new to the site.
so no flaming please, just looking for a little bit of advice.

Anyways, I just bought a fc n/a with blown apex seals
so i was planing on doing a TII swap, But the problem is, I dont know a whole lot about rotary engines, But ive been building old muscle cars since i was a kid, so im sure i could figure it out.
but the question is, is this just a pointless swap? Is it incredibly difficult?
i dont mind putting some blood and sweat into it. but if its something only a master mechanic can do... i just need to know.
and if not, a lil heads up on some of the things id be dealing with would be nice.
plus i was planning on just buying a whole front clip, if that would help.


thx,
and I appreciate any answers