RX8 6 speed Transmission swap
I did it. It's in my fd. The gearing is kinda rough. I only deponent this for track . Unless you have a 3.9 rear
When you use the Honda slave cylinder. Do you use the Honda arm or Mazda. My step brother kept the Mazda arm.
Under 8-10 PSi I feel like clutch is slipping. But could also be the slave has to much tension.
When you use the Honda slave cylinder. Do you use the Honda arm or Mazda. My step brother kept the Mazda arm.
Under 8-10 PSi I feel like clutch is slipping. But could also be the slave has to much tension.
Full Member
Joined: Nov 2004
Posts: 201
Likes: 5
From: GA
I would just like to bump this thread. It's been in the car working well. The Honda slave fits. The Honda rod has to be shortened. But the drive is great, you will loose speedometer, they have a GPS speed unit online that can tap into the stock wiring to get speed back working. I'm just using my phone GPS for the speed.
only downside is the 4" forward shifter is too close to the sterio so I had my rx8 shifter bent and welded at a weird angle but I would like to find a shifter or solution to put it at stock location.
I may be swaping to a rx8 5 speed Bell/fd center and rear case hybrid trans so I can keep my interior stock again.
only downside is the 4" forward shifter is too close to the sterio so I had my rx8 shifter bent and welded at a weird angle but I would like to find a shifter or solution to put it at stock location.
I may be swaping to a rx8 5 speed Bell/fd center and rear case hybrid trans so I can keep my interior stock again.
Not my first rodeo
Joined: Nov 2024
Posts: 39
Likes: 15
From: Florida
Thread
Thread Starter
Forum
Replies
Last Post
RX7freak08
2nd Generation Specific (1986-1992)
22
May 24, 2008 10:09 AM
