Rotor housing differences...
#1
Excessive Heavy Foot
Thread Starter
Rotor housing differences...
Are the front and rear rotor housings pretty much identical or entirely different?
I picked up a good front rotor housing and rotor for cheap, and looking for an additional rear set to assemble a new keg.
My current keg blew the apex seals in the rear set out and demolished it.. The front is good, I was wondering if I could just use another front set to make a complete engine. I already scrapped the junk rear set to compare differences and similarities so now Im needing some input..
Thanks
I picked up a good front rotor housing and rotor for cheap, and looking for an additional rear set to assemble a new keg.
My current keg blew the apex seals in the rear set out and demolished it.. The front is good, I was wondering if I could just use another front set to make a complete engine. I already scrapped the junk rear set to compare differences and similarities so now Im needing some input..
Thanks
#4
Excessive Heavy Foot
Thread Starter
Ok good, I shouldve clarified more but this is an 13b S5 engine that is N/A.
I appreciate it guys. So I guess I can just get this ball rolling then and finally finish this money pit.
I appreciate it guys. So I guess I can just get this ball rolling then and finally finish this money pit.
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM
cdn
2nd Generation Non-Technical and pictures
0
08-11-15 08:59 PM