Replacing all 3 belts on a 89 GXL?
#1
Riley Bickford
Thread Starter
Join Date: Nov 2009
Location: Florida
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Replacing all 3 belts on a 89 GXL?
i need to change all the belts in my car because theyre wicked worn and im not sure on how to get to putting the belts in. can anyone help me? i already have the new apporpriate belts for the car just need a how to. thanks
#2
Top Down, Boost Up
iTrader: (7)
There will be 4 belts: Air pump, alternator, P/S & A/C. If using the stock clutch fan, you'll need to undo the four 10mm nuts where the fan attaches to the water pump pulley. Pull the fan off the studs and out from the shroud to give yourself room to work. Remove the P/S and A/C belts first by loosening the 3/4" nuts in the center of the two idler pulleys. Adjust the 10mm tensioner bolts to allow slack in the belts, then take them off. For the alternator and air pump belts, loosen the bolts at the pivot points & the ones on the adjuster brackets.
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
7
08-31-15 07:49 PM