putting series 4/5 engine together
Thread Starter
Can Post Only in New Member Section
Joined: Dec 2010
Posts: 2
Likes: 0
From: nz
putting series 4/5 engine together
have got the motor in the car and was wondereing if theres any pages or where i would find them on where everything goes and screws in and goes to where on the motor. cheers
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
You mean the Factory Service Manual, available for download in the 2nd gen FAQ?
If you swapped an S4 engine into an S5 vehicle or vice versa, stick with the electronics and sensors from that vehicle and just use the engine block you swapped in.
If you swapped an S4 engine into an S5 vehicle or vice versa, stick with the electronics and sensors from that vehicle and just use the engine block you swapped in.
Thread Starter
Can Post Only in New Member Section
Joined: Dec 2010
Posts: 2
Likes: 0
From: nz
hi there i have put the series 4 block into a e30 bmw and wanting to find out what i can take off the inlet manifold and how everything else goes like oil lines for things and stuff like that.
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
Start with the FSM as mentioned.
Then, search the 2nd gen forum for "emissions removal diagram" which should show you a minimum vacuum routing diagram.
One thing to keep in mind: no matter what anyone says, DO NOT remove the BAC or the cold start thermowax system. Just trust me.
Then, search the 2nd gen forum for "emissions removal diagram" which should show you a minimum vacuum routing diagram.
One thing to keep in mind: no matter what anyone says, DO NOT remove the BAC or the cold start thermowax system. Just trust me.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
0
Aug 18, 2015 10:01 PM