Pulling motor question
#2
100,000rpm redline
Join Date: Mar 2009
Location: whore house aka your mom's house
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
if you have an engine hoist that will adjust the angle then pulling motor and tranny at the same time is a little simpler since the bolts are hard to remove.
i removed the engine itself on my fc left the tranny bolted up and later found out my throw out clutch bearing was broken. might have been from removal. so i recommend pulling both.
i removed the engine itself on my fc left the tranny bolted up and later found out my throw out clutch bearing was broken. might have been from removal. so i recommend pulling both.
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM