Power Gone
#1
Junior Member
Thread Starter
Join Date: Feb 2013
Location: fresno california
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Power Gone
Well looks like my engine decided to take a turn for the worse an completly go to crap. I was gonna take my car for a drive in the morning to work but when i stated to drive it took a dump. In first gear everytime i oush the gas it wants to die out, i have replaced the fuel pump and filter to see if those were the reasons why the car was losing power but i guess not. Well with a little persistence on my end i managed to get a hold of the previous owner and asked him if he had ever rebuilt the engine an to my amazement (sarcasm) he had not. So in all the 188.xxx.xxx mile the engine has compiled not once has it been rebuilt. So my question is this, does anyone know of any engine rebuild shops near or around my area, i am located in fresno california but i would be willing to travel to L.A or San Francisco to get the engine rebuilt. So if anyone has any info it is greatly appreciated.
Last edited by misterstyx69; 03-23-13 at 04:25 AM.
#2
Junior Member
Join Date: May 2011
Location: Highland,CA
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
we've got some shops down here near L.A,have you looked at any of the vendors here in the vendor section?I've got my engine sitting on my garage floor and trying to decide where to take it.We have a shop called Lucky 7 racing that seems really good.
#4
Junior Member
Thread Starter
Join Date: Feb 2013
Location: fresno california
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
No havent really checked out the vendor section it wouldnt allow me to it said i needed to have five posts,an does that shop have a website.
An diabolical1 no i have not checked compression yet but i will now that you mention it. Im just prepareing myself for the worst if it needs a rebuild cause it has accumulated 188,xxx,xxx miles and the car sat for three years. An not to mention i am new to rotary engine cars lol but thatnk you guys for the info an insight it is much appreciated.
An diabolical1 no i have not checked compression yet but i will now that you mention it. Im just prepareing myself for the worst if it needs a rebuild cause it has accumulated 188,xxx,xxx miles and the car sat for three years. An not to mention i am new to rotary engine cars lol but thatnk you guys for the info an insight it is much appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM