porting s6 13btt
Thread Starter
Can Post Only in New Member Section
Joined: Mar 2010
Posts: 2
Likes: 0
From: loganholme
porting s6 13btt
hey everyone, i am in the process of porting my s6 13btt. i am doing a large extended port, jus wondering how big can i go with the primary ports in comparison to the secondary ports.
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
If you are of any doubt, you should buy a porting template.
The primary port casting is about twice as small as the secondary, so the answer is NOT FAR. About 4MM up with a taper, and 4MM down with a taper should keep you out of the danger zone. But you probably don't want to go that big. Often just minor work on the primaries results in the best low end.
The primary port casting is about twice as small as the secondary, so the answer is NOT FAR. About 4MM up with a taper, and 4MM down with a taper should keep you out of the danger zone. But you probably don't want to go that big. Often just minor work on the primaries results in the best low end.
Thread
Thread Starter
Forum
Replies
Last Post
iamsisyphus
2nd Generation Specific (1986-1992)
6
Sep 27, 2015 01:42 PM
