Need help running GSL-SE injectors on standalone FC
Need help running GSL-SE injectors on standalone FC
When I bought my car (S4FCT2), it came with the stock ECU, S-AFC and runs the 195500-0900 orange top GSL-SE (I think they're 680cc?) secondaries (not too sure about primaries yet, I'll go check). I just recently bought an Adaptronic eMod009 and going through injector setup settings, I can't find the injectors I need in the list. Does anyone have the full list of specs (for those injectors so I can set them up properly? *Note: The resistor box is still in use since they're low impedance*.
Thanks!
Thanks!
i didn't see anything in the FSM that laid out an official spec for them, but here's a thread that should give you what you need:
https://www.rx7club.com/1st-generati...ectors-811012/
https://www.rx7club.com/1st-generati...ectors-811012/
Thread
Thread Starter
Forum
Replies
Last Post






