Need help running GSL-SE injectors on standalone FC
#1
Junior Member
Thread Starter
Need help running GSL-SE injectors on standalone FC
When I bought my car (S4FCT2), it came with the stock ECU, S-AFC and runs the 195500-0900 orange top GSL-SE (I think they're 680cc?) secondaries (not too sure about primaries yet, I'll go check). I just recently bought an Adaptronic eMod009 and going through injector setup settings, I can't find the injectors I need in the list. Does anyone have the full list of specs (for those injectors so I can set them up properly? *Note: The resistor box is still in use since they're low impedance*.
Thanks!
Thanks!
#2
Moderator
iTrader: (3)
i didn't see anything in the FSM that laid out an official spec for them, but here's a thread that should give you what you need:
https://www.rx7club.com/1st-generati...ectors-811012/
https://www.rx7club.com/1st-generati...ectors-811012/
#3
Junior Member
Thread Starter
Yea I already looked at that but it's missing information like the minimum fuel volume, min eff. pulse width and dead times. Seems like this info isn't available anywhere...
Thread
Thread Starter
Forum
Replies
Last Post