need help with idle
#1
Junior Member
Thread Starter
Join Date: Jan 2012
Location: NC
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
need help with idle
I have an 85 GSL and pulled off the carb for a rebuild. I put the carb back on and the car is running great over 2000 rpms. Below 2000 it lugs badly and won't idle. It tries to idle, but lugs a sec or two and then quits running. Do you think this can be adjusted or is it a vac leak? I am not very familiar with carb work so any advice will be appreciated!
#2
I have an 85 GSL and pulled off the carb for a rebuild. I put the carb back on and the car is running great over 2000 rpms. Below 2000 it lugs badly and won't idle. It tries to idle, but lugs a sec or two and then quits running. Do you think this can be adjusted or is it a vac leak? I am not very familiar with carb work so any advice will be appreciated!
#3
Junior Member
Join Date: Feb 2010
Location: Albuquerque, NM
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
If that doesn't help, try tightening the idle speed screw located on the driver side of the carb next to the accelerator pump adjusting nut. Sterling has a good walkthrough on how to tune your carb. Just check the first gen faq.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM