My rx7 fc wont start after rebuild
Thread Starter
Can Post Only in New Member Section
Joined: Jan 2018
Posts: 2
Likes: 0
From: Serbia
My rx7 fc wont start after rebuild
Hey guys, I need help! I drive an mazda rx7 fc turbo 2 1991. Now, here's the whole story. My rebuilted motor doesn't want to start! The engine is cranking, has a spark, compression but still won't start. Spark plugs are not NGK bur9 eq and bur7 eq. I put other spark plugs, but with the same temperature value. Trailing 9, and leading 7. Does that has to do anything with the fact that my engine wont start? 
Thanks!
Thanks! 
Joined: Aug 2002
Posts: 2,614
Likes: 31
From: Freeland, MI
Rebuilt engines can be a hassle to get started the first time. I would start out with a compression check and make sure your getting 3 even bounces on each rotor, cause if not you'll be chasing your tail
If that checks out, make sure your fuel injectors are working by taking off the fuel rail but leave the injectors hooked up, setting the engine to TDC, take out the distributor (i'm brain farting on the actual name of it) and give it a spin with the key on, this will help you visually check for spark AND fuel should be squirting from your injectors
If this all checks out, put it all back together, and get a buddy with a truck to pull start the car (2nd gear for this)
If that checks out, make sure your fuel injectors are working by taking off the fuel rail but leave the injectors hooked up, setting the engine to TDC, take out the distributor (i'm brain farting on the actual name of it) and give it a spin with the key on, this will help you visually check for spark AND fuel should be squirting from your injectors
If this all checks out, put it all back together, and get a buddy with a truck to pull start the car (2nd gear for this)
Thread
Thread Starter
Forum
Replies
Last Post
Nelio
New Member RX-7 Technical
4
Dec 29, 2008 12:20 PM
OWNED
2nd Generation Specific (1986-1992)
20
Apr 5, 2005 02:13 PM
WeazelOne
2nd Generation Specific (1986-1992)
1
Oct 22, 2002 11:18 AM