Lapping "Irons" Question
#1
Passenger
Posts: n/a
Lapping "Irons" Question
I'm in the process of rebuilding my motor for the first time. I'm using J.H.B Cermet-X rotor housings with 3mm ceramic apex seals. 2 of my irons need lapped. I was thinking of sending them to MazdaTrix for Lapping and trying the WPC treatment. Any suggestions or opinions would be greatly appreciated.
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
I'm far from knowledgeable on these treatments and coatings, but from what I have read they are very hit or miss. As such, I would not use any on any of my engines.
Why are you running ceramic apex seals? You are probably aware but they are VERY expensive and generally overkill for street use.
Why are you running ceramic apex seals? You are probably aware but they are VERY expensive and generally overkill for street use.
#3
Passenger
Posts: n/a
Why ceramic? Well Marc at J.H.B gave me a hell of a deal on the combo. Plus I plan on going to a single turbo so I'm trying to build a strong reliable motor. So what would you suggest for the irons? I understand that once I lapp I will remove the nitriding. Isn't that a bad thing? Has anyone ran a lapped plate without any hardening process done to it?
Thread
Thread Starter
Forum
Replies
Last Post
AMOC
SE RX-7 Forum
1
09-10-15 09:42 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM