Hi Everyone/Anyone, just wondering if you could help me??
I have an 808 with a s5 13bt microtech lt10s I was running the standard s5 coils but have decided to use LS1 coils, I have wired the coils to the diagram which I think is right (correct me if Im wrong, lol). I put the ecu in test mode and Im not getting spark from L2 coil (Grey/Black) and I cant find anywhere that says where to wire the tacho outout (Grey/Blue) to the coils. Any help with this would be greatly appreciated.
Regards
Joe

 

Suggestion.
Gain some post by following the Colored INFO threads up top in the INTRO section,then post your problem in the Microtech section of the Forum.
I run Haltech.
I know when I switched from the stock coils to the AEM coils that the settings had to be changed.
WARNING!..do not have power to the coils while changing the settings as ONE coil actually Blew up and spewed Goo!
It was brand new too,so it was an expensive lesson.

 

thanks misterstyx69 Ill do that.. Cheers