how hard is it
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
You'll need to fabricate mounts for the engine and transmission, likely trim part of the transmission tunnel, figure out how to mount a shifter so it doesn't look terrible, fabricate exhaust and intercooler piping, and then wire it all up.
Check out the Other Engine Conversions section for examples.
Check out the Other Engine Conversions section for examples.
Joined: Jul 2008
Posts: 2,515
Likes: 4
From: San Jose, CA (NorCal/S.F. Bay Area)
So there is an 11 page thread on the topic here: https://www.rx7club.com/other-engine-conversions-non-v-8-118/4g63-rx7-216603/
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
Jun 3, 2024 03:25 PM