Few Questions on 13bt S5 Swap
05-23-11, 04:27 PM
#1
Junior Member
Thread Starter
Join Date: Feb 2011
Location: Seattle, WA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Few Questions on 13bt S5 Swap
Soon i will have a jdm 13bt engine to swap into my 90 N/a.
Just wondering what parts i might need if i have...
- Engine
- Turbo
- ECU
- Intercooler
I was thinking about using my N/a tranny just untill i can save to buy the rear end and then turbo tranny.
Are silicone hoses best or should i just get regular hoses?
Any tips you can give me would be awsome.
Just wondering what parts i might need if i have...
- Engine
- Turbo
- ECU
- Intercooler
I was thinking about using my N/a tranny just untill i can save to buy the rear end and then turbo tranny.
Are silicone hoses best or should i just get regular hoses?
Any tips you can give me would be awsome.
05-23-11, 04:48 PM
#2
Please read the 2nd gen FAQ, which is stickied at the top of this section: https://www.rx7club.com/showthread.p...55#post5131155
05-23-11, 07:40 PM
#3
your average radiator hose is fine.... unless u want to dress up your engine bay to make it look presentable....
your gonna need what ur list has and a whole lot of other things....
s5 T2:
fuel pump
injectors
pressure sensor
MAF
and your gonna need a custom DP to mate your NA exhaust to the turbine unless ur gonna get a full turbo back exhaust...
there are other things as well look in the FAQ this question is covered several times on there...
your gonna need what ur list has and a whole lot of other things....
s5 T2:
fuel pump
injectors
pressure sensor
MAF
and your gonna need a custom DP to mate your NA exhaust to the turbine unless ur gonna get a full turbo back exhaust...
there are other things as well look in the FAQ this question is covered several times on there...
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
