Customized Engine Stand for 1st gen 12A?
#1
Junior Member
Thread Starter
Join Date: May 2012
Location: Kirkland, wa
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Customized Engine Stand for 1st gen 12A?
I have seen pictures and videos where it looks like an engine stand has been modified to hold the 12a engine by the side instead of the back. It looks like people may be using wood. I have tried searching the forum, but haven't come up with a description of how to do this.
Can someone point me to a post or page with recommendations?
Thanks.
Can someone point me to a post or page with recommendations?
Thanks.
#2
Top Down, Boost Up
iTrader: (7)
A lot of people just make them themselves out of scrap metal, but Mazdatrix sells one and I'll bet some of the other rotary specialty shops do too (such as Racing Beat).
http://www.mazdatrix.com/toolmisc.htm
http://www.mazdatrix.com/toolmisc.htm
#4
Senior Member
iTrader: (1)
Join Date: Aug 2010
Location: Southern Minnesota and Southern California
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
Just remove the power steering bracket. The standard engine stand adapter fits on that perfectly. Two different bolt sizes are needed. Remove the studs.
Thread
Thread Starter
Forum
Replies
Last Post
craaaazzy
Comments and Suggestions Archive
3
08-21-15 02:00 PM