New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

Cranks, but won't start, but isn't flooding

Thread Tools
 
Search this Thread
 
Old 05-01-13, 08:16 AM
  #1  
Can Post Only in New Member Section
Thread Starter
 
grandpas car's Avatar
 
Join Date: May 2013
Location: Chilliwack
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Cranks, but won't start, but isn't flooding

So this has been really bugging me. I went to start my 1987 turbo 2, but all it does is crank. It has 10L of fresh fuel in it, and I can't smell any gas as if it where flooding ( I have a fuel shut off inside the car to prevent that). Last time it ran was about a month ago, and I think I ran it out of gas, as well it was doing the 3800rpm stuter. Is it just in need of a fuel systems tune up?
Old 05-01-13, 08:17 PM
  #2  
Retired Moderator, RIP

iTrader: (142)
 
misterstyx69's Avatar
 
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes on 114 Posts
Check the plugs to se if it is flooding.
Your nose is not the best diagnostic tool sometimes.
Is the fuel shut off: off?.(can happen)
also If the plugs are wet you are getting fuel so go through a TOTAL deflood not just pulling an EGI fuse.
Starting Fluid( aka Ether) is also a good thing to have to see of it is NOT gettng fuel as it will run when sprayed and then Die when it runs out of the spray.
That way it would tell you if it is fuel related.
You just posted Basics,so that is the Basic starting point.
If you find out more Post up.
Old 05-01-13, 08:31 PM
  #3  
Moderator

iTrader: (1)
 
satch's Avatar
 
Join Date: Jun 2005
Location: tulsa,ok.
Posts: 11,738
Received 12 Likes on 11 Posts
Make sure the 15 amp Engine fuse is good.
Old 05-02-13, 01:52 PM
  #4  
Can Post Only in New Member Section
Thread Starter
 
grandpas car's Avatar
 
Join Date: May 2013
Location: Chilliwack
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Ok cool, I'll have to give that a go. Thanks guys
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
1993fd3sracer1
3rd Generation Specific (1993-2002)
29
10-13-15 01:57 PM
1993fd3sracer1
1st Generation Specific (1979-1985)
20
09-07-15 11:50 AM
PhillyFC
General Rotary Tech Support
9
08-21-15 06:36 PM
Im faster
General Rotary Tech Support
4
08-19-15 02:57 PM



Quick Reply: Cranks, but won't start, but isn't flooding



All times are GMT -5. The time now is 09:15 AM.