New Member RX-7 Technical Post your first technical questions here, in an easy flame free environment, before jumping into the main technical sections.

cold start stall

Thread Tools
 
Search this Thread
 
Old 07-13-11, 09:44 PM
  #1  
Junior Member
Thread Starter
 
81redrx7's Avatar
 
Join Date: Mar 2011
Location: virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
cold start stall

hey guys, just got a second fb rx7 (82) got for pretty much nothing it was in hurting condition carb was junk cat clogged and missing many interior and body was faded and several dings through out just finished all body work and most of the interior, i swapped out carb from my 81 that was not running (no compression) and a after market exhaust car now runs perfect hot but when cold wants to stall, when the old carb was on the car it would start perfect idle up and then choke would pull back in then stall.the carb from the 81 choke has to be pushed back in and wont run right until hot what on the carb causes this situation to happen?
Old 07-14-11, 04:19 PM
  #2  
Junior Member
Thread Starter
 
81redrx7's Avatar
 
Join Date: Mar 2011
Location: virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
cold stall until warmed up

hi everybody i currently have 2 rx7s an 81 and 82 currently using the 81 as parts car for the 82. i got 82 and the carb was in bad shape but it would idle great untill it warmed up then it would stall so i pulled the carb from the 81 and put it onto the 82 car wont idle on its own now cold the choke has to be pushed in manually once warmed up it works perfect idles great rev response is spot on jus wont idle and stalls when cold what on the carb would cause this issue during warm up? i have an old haynes manual and it says to check the anti-afterburn valve? im not great with carbs more of fuel injected guy, does this sound like the issue i might be having?
Old 07-14-11, 11:33 PM
  #3  
Administrator

iTrader: (8)
 
mar3's Avatar
 
Join Date: Nov 1998
Location: So. Arlington, TX!!!
Posts: 12,974
Likes: 0
Received 59 Likes on 36 Posts
The carburetor is the problem if it sat for more than 2 years with gas in it, especially any ethanol-blend gas in it. Time for a rebuild. As you go about replacing and cleaning things, you're also going to fix a host of smaller problems that would've popped up later making you think you did the rebuild wrong when you couldn't tune it.

Mario III
Old 07-16-11, 09:59 PM
  #4  
Junior Member
Thread Starter
 
81redrx7's Avatar
 
Join Date: Mar 2011
Location: virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
thanks mars3 i got the carb running mint now the bimetal spring on the side of the carb was broken, the linkage was a little tight,and the accelerator pump was leaking little bit. some pb blaster and bimetal spring from other carb and new gasket for the acclerator pump cover and now running perfect. while fixing that i noticed a leak in radiator swaped it out from the other car shes almost ready to go on the road need to remove windshield from other car,a windshield wiper motor, paint, horn and dash not bad spending 200$ on the car and fixing it so far!
Old 07-17-11, 10:32 PM
  #5  
Administrator

iTrader: (8)
 
mar3's Avatar
 
Join Date: Nov 1998
Location: So. Arlington, TX!!!
Posts: 12,974
Likes: 0
Received 59 Likes on 36 Posts
That is great to read - that little rex just found a great new owner!


Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
whinin
Introduce yourself
17
03-30-19 07:53 PM
rx7shirley
2nd Generation Specific (1986-1992)
6
09-02-15 02:11 PM
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM



Quick Reply: cold start stall



All times are GMT -5. The time now is 05:25 AM.