Break mount question
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Jul 2009
Location: Colorado
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Break mount question
since this is my first post I will say Hi all!
my question is something that I have been looking for a while for. unfortunatly I have not had the time to actually pull the part and measure it. I was wondering if anyone here had the data I am looking for.
what is the size, thread count, and grade of the break calliper mounting bolts? I have tried standard metric sizes and UNC and UNF sizes. no luck. my only other option is to forcefully remove the bolts from my other break.
note: 1985 RX7 stock.
thanks a bunch. looking forward to being part of this community.
my question is something that I have been looking for a while for. unfortunatly I have not had the time to actually pull the part and measure it. I was wondering if anyone here had the data I am looking for.
what is the size, thread count, and grade of the break calliper mounting bolts? I have tried standard metric sizes and UNC and UNF sizes. no luck. my only other option is to forcefully remove the bolts from my other break.
note: 1985 RX7 stock.
thanks a bunch. looking forward to being part of this community.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM