89 fc wont idle
12-26-13, 07:07 AM
#1
Junior Member
Thread Starter
Join Date: Aug 2004
Location: Phoenix, AZ
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
89 fc wont idle
I just deleted the omp and the smog pump. In the process pretty much all of the vacuum lines broke. I went through and replace all the lines that I could see were broken as I reassembled the intake. When I fired it up she rev'd like mad. I blip the throttle and it stops revving all the way up but won't idle at all. Without giving gas the car just dies. Any suggestions, maybe there is a vacuum leak somewhere that I didn't see, or I screwed up putting the throttle cable back on? Thanks
12-26-13, 10:03 AM
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Congratulations.But SORRY...in a BAD way.
You can't remove the OMP from a Series 5 or the ECU goes into limp mode.
And the smog pump is used to activate the VDI (aux ports)
So unfortunately those "mods" that you have done just set you back 2 steps.
You can't remove the OMP from a Series 5 or the ECU goes into limp mode.
And the smog pump is used to activate the VDI (aux ports)
So unfortunately those "mods" that you have done just set you back 2 steps.
12-26-13, 10:08 AM
#3
Junior Member
Thread Starter
Join Date: Aug 2004
Location: Phoenix, AZ
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
So I can't just leave the omp plugged in while I get the Ecuador chipped? Also the smog pump has to be in place? I couldn't just put a hose from the air box? Damn. That's what I get for not reading up.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
