hi i was trying to replace my old driver side headlight for my 88 rx7. so i replaced the old headlight because it wouldnt turn on anymore. so i replaced it with the hid headlight and with the hid kit. the light turns on but it flickers and turn off. i doubt its either the light bulb or the ballast though because i connect the wires straight to the battery already. i need help!

 

actually one headlight would turn on and the other woudnt turn on. then when the other headlight turn on the other headlight wouldnt turn on

 

if anything re-wire your lights, there could be a short in your harness, relay, or somethings not grounded right.
What is the history on this car, anyone rewire anything, has anything been removed, wrecked?
what i would try and do is replace both at the same time, ive seen headlights acting like that becuase one of the ballast or wire is busted, or shorting out

 

it just been sitting on my friend's driveway for a long time. the motor and the car was seperated from eachother so i took the car and while doing maintenance in my garage i was trying to clean up the shell buy new parts so i bought new hids thinking one of the light bulb on the headlight were out.

 

Take ur lights completly off. Check the actual plugs where the light plugs into for corrosion and the wires running from them for any melted spots or corrosion. I just did this and fixed mine today

 

What kind of HId's you got?

 

I would also check for a grounding issue.

 

problem solved, i bought a new relay kit because i was reading other thread people said there suppose to be a relay but i dont see any so i bought a relay kit

 

hope that the relay works for you

 

check the grounds or motor

 

Check the fuse. Or maybe is it a cheep $50 hid kit??????