Got this car a week ago dont have a clue about it and it will turn over but no run. I took the plugs out and couple are clean and the other two have oil on them. Any suggestions on whats wrong or is it time for engine swap?

 

Hopefully, this older thread will have information you can use to get that sucker started!

https://www.rx7club.com/new-member-rx-7-technical-256/1980-rx-7-wont-start-862775/

Mario III

 

I will have to try this out after work. Thanks!

 

Trevor0690

if you still can not get it to run, Pm me, I am more than happy to help where I can. I am new to the boards, but have been working on rotary's for about 20 years now. I have foudn there is a ton of info out here on this board, so you came to the right place. Welcome

Doc

 

Thanks Doc. I have recently not been able to get power to the cae now The jump wires are burnt and now i at stand still and do not know what to do> Really frustrating as i was gunna do a compression test haha.

 

Got the power situation all done and did a compression test and got (0) on all of the.

 

If the motor is flooded, compression will read zero anyway. Make sure that the spark plugs are sparking. If so, then dump a couple of ounces of Seafoam down the carb, then try it again. That will usually get a flooded rotary back on its feet.










.