13B '96 Housing wear
Thread Starter
Newbie
Joined: May 2017
Posts: 4
Likes: 0
From: Amsterdam
13B '96 Housing wear
Hi,
Yesterday I tear down my engine for a good clean and rebuild.
I was wondering if my housings and side housings are good enough for a rebuild.
Can you guys give your expertise ? The lines you see on the side housings are not sensible. The horizontal marks on the rotor housings are light sensible.
Thank you in advance!
Yesterday I tear down my engine for a good clean and rebuild.
I was wondering if my housings and side housings are good enough for a rebuild.
Can you guys give your expertise ? The lines you see on the side housings are not sensible. The horizontal marks on the rotor housings are light sensible.
Thank you in advance!
Last edited by Jeroen93; Feb 24, 2018 at 12:14 PM. Reason: Addition of information
IIRC inspection and clearances are mostly set out in the Factory Service Manual in Section 'C'. If you haven't yet, a copy can be downloaded free from the FAQ sticky at the top of this section. Personally I can't tell much from the pictures.
Thread
Thread Starter
Forum
Replies
Last Post
patman
2nd Generation Specific (1986-1992)
3
Sep 23, 2002 08:51 PM